Hi all,
I'm experiencing pretty slow USB OTG Write speeds while copying my nandroid backup. Currently I'm getting between 2.5-4.5MB/sec.
I'm using the much praised Anker USB C-A OTG cable with a little red SanDisk USB 2.0 micro SD adapter and a 64Gb Samsung Pro micro SD card thats rated at 95(read)/90MB(write)/s. Internally it was pretty fast in my MxPE. It definitely didn't hit the advertised speeds but was definitely faster by a factor of at least ten than the highest speeds I'm im getting now with my OTG cable. IIRC I also obtained similar speeds using the same SanDisk USB adapter on one of my desktops.
Anyone have any ideas? Should I just cut the whole sd/usb adapter out of the setup and just use a thumb drive with my OTG cable? Is there possibly something that I am doing very wrong?
-MeeGz
I'm experiencing pretty slow USB OTG Write speeds while copying my nandroid backup. Currently I'm getting between 2.5-4.5MB/sec.
I'm using the much praised Anker USB C-A OTG cable with a little red SanDisk USB 2.0 micro SD adapter and a 64Gb Samsung Pro micro SD card thats rated at 95(read)/90MB(write)/s. Internally it was pretty fast in my MxPE. It definitely didn't hit the advertised speeds but was definitely faster by a factor of at least ten than the highest speeds I'm im getting now with my OTG cable. IIRC I also obtained similar speeds using the same SanDisk USB adapter on one of my desktops.
Anyone have any ideas? Should I just cut the whole sd/usb adapter out of the setup and just use a thumb drive with my OTG cable? Is there possibly something that I am doing very wrong?
-MeeGz
No comments:
Post a Comment